![]() This bracket allows you to move the rod up or down depending on the thickness of the wall, so that you get an even grip, no matter what. When dealing with lath and plaster walls, the best way to hang your curtains is by using specialty curtain rods that come with an adjustable bracket. This combination makes them thicker than drywall and more prone to movement, so it’s important to have the right hardware on hand when hanging your curtains. Lath and plaster walls are an older style of walling that is created using a combination of thin wooden strips or laths and a wet plaster material. When it comes to hanging curtains on lath and plaster walls, it’s important to understand what you’re dealing with first. How? Simply click here to return to Rehabber Answers to Questions Questions.8 FAQS Understanding Lath and Plaster Walls Join in and write your own page! It's easy to do. If you'd like to add more pictures or start your own page, use the link below that. If you'd like to add to this page, use "click here to add your own comments" below. That for me is much easier, faster, and less expensive than shimming, patching, and cleaning the cavities behind the moldings.Īnd it looks like a new house versus a re-worked project house. That last project I did only required 2 new 8-foot replacement boards to match the old molding. I add new boards in the less visible areas like the closets. I use the original moldings in the visible areas. My choice of finish is linseed oil for a natural look unless I'm painting. I've used paint stripper, belt sanders, but the easiest way for me was to run them through an inexpensive wood-planer. ![]() ![]() Those old style wood moldings from the 1920's are usually Douglas Fur-(pine) or Oak and can be purchased at the lumber yards and home remodeling centers.Īfter I install the new sheetrock, I strip the old molding of its paint or shellac finishes. My concern with that is, that creates more room for error when the sheetrock is installed and you may end up with a wavy wall. You'd have to rip 2 X 4 studs one inch to shim each existing wall stud. Like you mentioned, 3/4" plaster and 1/4" lath,Įach stud would have to be shimmed 1-inch. The broken plaster during demolition will accumulate behind the moldings in between the studs.Įxtra clean out work, but lots of money saved from buying replacement wood moldings. The plaster was cut above the molding with a reciprocating saw and circular saw with settings not to cut into the studs.Īfter the new sheetrock was installed, a decorative style of molding was used to cover the exposed plaster and lath behind the molding and the new sheetrock.Īccess for new plumbing, electrical, and insulation are not a problem because the maximum heights of the old wood moldings were 7-1/2 inches. I have seen plaster and lath wall replacements without removing the old moldings. In that case, I've used wood glue and clamps for that repair. Pulling the boards from one end only, is often likely to break. The trick to careful removal of the old moldings are to delicately start at one end with a pry bar, lever or pry the board about 1/4", then move down the board in 12" increments to the end, then start over. There is no doubt, the wood moldings and casings are going to be brittle after 90 years.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |